These DIY toy embedded soap bars are an adorable way to make shower time more fun! Oh the possibilities for soapy sweet favors and gifts. Purchase materials for this project here: http://bit.ly/2uX5keA
DIY Toy Embedded Soap
Cut clear soap base into cubes and melt in microwave. Start with 30 seconds on high power and stir. Repeat until soap is mostly melted, then stir until completely melted.
Add a few drops each colorant and fragrance oil.
Fold mold ¼ inch full. Allow to form a firm skin, spray toy with alcohol, then press toy into soap layer.
Spray soap and exposed side of toy with alcohol, then top off with remaining soap. You may need to warm up your soap again.
Allow to harden at room temperature, freeze for 10 minutes. Invert mold and pop out by pushing with your thumbs. Pulling the edge of the mold away from the hardened soap will help release the bar if it’s not coming out easily.